For wave soldering, the tail should protrude 1.0–1.5 mm below the board after insertion. Under 0.8 mm the joint starves; over 2.0 mm the solder wicks up the pin and bridging risk rises. Measure from the board’s bottom surface, not from the pad.
Most tail problems come from specifying the pin length without specifying the board thickness. The same 11 mm header is correct on a 1.6 mm board and marginal on a 2.4 mm board.
The numbers
| Board thickness | Minimum tail below board | Recommended pin length |
|---|---|---|
| 1.0 mm | 1.0 mm | 8.5–9.0 mm |
| 1.6 mm | 1.0–1.5 mm | 10.5–11.0 mm |
| 2.0 mm | 1.0–1.5 mm | 11.5–12.0 mm |
| 2.4 mm | 1.2–1.5 mm | 13.0 mm |
Those lengths include the part of the pin above the board that forms the mating post. A stacking application needs more above the board, which pushes the total up again.
Too short: the starved joint
Wave solder fills a joint by capillary action around the pin and up into the barrel. If only 0.5 mm of pin clears the board, the solder has nowhere to form a fillet, and the joint becomes a flat disc that cracks under thermal cycling.
It passes AOI, because the joint looks filled from above. It fails after a hundred thermal cycles, usually at the pin nearest the board edge where the thermal gradient is worst.
Too long: wicking and bridging
A long tail acts as a heat path and a solder path. Solder climbs the pin and can reach the housing, which is both a cosmetic defect and a mechanical one: solder in the pin entry area stops the pin from floating during thermal expansion.
Long tails also increase bridging between adjacent pins on 2.54 mm pitch, because the extra metal holds heat and the solder stays molten longer as the board leaves the wave.
What to put on the drawing
- Pin length overall, and the length below the board after insertion.
- Board thickness assumed, with a note that a different thickness needs a different pin length.
- The housing standoff, if the part sits on a spacer.
- Whether the tails are straight or have a chamfer for easier insertion.
Press-fit is different
A press-fit pin does not solder; it deforms in the hole and forms a gas-tight joint. Tail length there is set by the via depth and the tooling, not by a solder fillet. Do not apply wave-solder tail rules to a press-fit part.
Can I cut pins to length myself?
You can, and for prototypes it is normal. Cut with side cutters that do not crush the pin, then check the cut end for burrs. A burr larger than 0.1 mm will not enter the socket.
Does the hole size change the tail requirement?
Yes. A hole 0.1 mm oversize takes more solder to fill and needs a slightly longer tail. The standard 1.0 mm hole for a 0.64 mm square pin is the reference.
What about selective solder?
Selective soldering is more forgiving than wave because each joint gets its own heat. It still needs 0.8 mm of protrusion to form a fillet, but tolerates longer tails better.
Tell us the board thickness and the soldering process and we will confirm the pin length before the order, not after the first build. See the pin header range; for the layout side read wave soldering layout details.