Add keying whenever two identical connectors sit on the same board or panel and can be swapped. A molded slot, a filled position or a different colour costs cents and removes the most common assembly error in multi-connector equipment.

Polarization and keying are two different things and both are worth having: polarization stops the connector going on backwards, keying stops it going into the wrong socket.

Four ways to key a connector

Method Cost Prevents Limitation
Molded polarizing slot Free, standard on shrouded parts Reverse insertion Only one orientation
Filled pin position Low, but a mold change if not standard Wrong socket Loses a circuit
Different colour housing Low, above MOQ Wrong socket Visual only, no mechanical stop
Keying plug Low, added at assembly Wrong socket Can be left out

Colour coding is the weakest of the four because it relies on someone looking. It works well as a second layer, not as the only layer.

The panel case

A control cabinet with four identical 10-pin connectors is the classic failure: an assembler plugs the motor cable into the sensor port, everything powers up, and the fault appears when the machine moves. Keying by filling a different position in each connector makes the swap physically impossible.

The cost is one mold insert change at the factory and zero at assembly. It is the highest return per cent of any connector feature we sell.

Polarization on unshrouded headers

An open pin header has no polarization at all. If the mating socket can be reversed, add a shroud with a slot or fill a pin. On a symmetric pin field, reversing the connector is electrically silent until something is damaged.

Can I add keying after the fact?

Only with a keying plug or by cutting a pin, and cutting changes the current path. A molded feature is a factory decision, so decide before the tool is cut.

Does keying change the footprint?

A filled position does, because the hole disappears. A polarizing slot does not. Check both against the layout before release.

Is colour coding enough on its own?

No. It fails whenever the light is poor, the operator is new, or the housings are dirty. Use it with a mechanical key.

Tell us how many identical connectors are on the panel and we will propose a keying scheme that makes the swap impossible, not just discouraged. Shrouded parts are in the box header section; the general case is in shrouded or open header.