Use tape and reel for automated placement above a few thousand pieces, tubes for small runs and through-hole parts, trays for large or odd-shaped bodies. The rule is not cost per unit, it is whether the feeder can present the part reliably at the rate your line runs.
Packaging problems rarely look like packaging problems. They look like bent pins at incoming inspection, feeder jams, or a placement head that picks the part at a slight angle and puts it down 0.3 mm off.
What each format is good at
| Format | Typical volume | Strength | Weakness |
|---|---|---|---|
| Tape and reel | 5,000+ | Fast, machine-friendly, protects coplanarity | Tooling charge for the pocket; long lead on new sizes |
| Tube | 50–2,000 | Cheap, reusable, good for through-hole | Parts slide and rub; pins can catch |
| Tray | Any | Best protection for big bodies | Manual loading, slower line |
| Bulk bag | Prototypes | Cheapest | Bent tails, no coplanarity guarantee |
The pocket is the engineering
A tape pocket has to hold the part so it cannot rotate, cannot lift, and cannot touch the cover tape. For a connector with pins on one face, the pocket depth is set by the pin length plus a clearance, and the pocket width by the body plus a small clearance.
Get the depth wrong in one direction and the pins punch through the cover tape. Get it wrong in the other and the part rattles, which bends tails during transport. This is why a new pocket is a tooling item, typically 7–10 days, not a stock item.
EIA-481 and the numbers your feeder expects
- Reel diameter 330 mm standard, 180 mm for small quantities.
- Pocket pitch must be a multiple of 4 mm.
- Feed hole pitch 4 mm, 2 mm for fine pitch parts.
- Cover tape peel force 0.1–1.0 N, measured at 300 mm/min.
If the peel force is too high the feeder stalls; too low and the part falls out in the reel. Both show up as intermittent pickup errors that are blamed on the nozzle.
Protecting coplanarity
SMT parts live or die on tail coplanarity. A tube lets parts slide against each other, and a 2×20 body with 0.1 mm tails will not survive that. Tape holds each part in its own pocket, which is the real reason to pay for it.
If you must use tubes for SMT parts, ask for the anti-static tube with internal ribs and specify that tubes are not stacked more than five high in the carton.
Can I get tape and reel for 500 pieces?
Yes, but the pocket tooling and the reel setup are charged, so the per-unit cost is poor. Below 2,000 pieces tubes are usually the better deal.
Is antistatic packaging required?
For plain connectors, no. For parts with exposed contacts handled near sensitive devices, yes. Ask for the black conductive tube or the dissipative tape if the assembly is ESD-controlled.
Does packaging affect the price per piece?
It can add 2–5% at low volume and less than 1% at high volume, mostly through the pocket tooling amortisation. The assembly-line savings are usually larger than the packaging cost.
Tell us the part, the annual volume and the feeder type on your line, and we will quote the packaging that will not stop it. SMT parts ship in tape and reel from the pin header range.