Pick the body height from the gap you need between the two boards. 5.0 mm bodies give roughly 3.5–4.5 mm of clearance above the PCB; 7.1 mm gives about 6 mm; 8.5 mm gives about 7.5 mm. If you do not yet know the gap, pick 8.5 mm and shorten the mating pin header later, because cutting a pin header is cheaper than changing a mold.
The number on the datasheet is the insulator height, from the board surface to the top of the plastic. What the mechanical designer needs is the distance between the two boards, which also depends on the male header and on how far the pins engage.
The three standard heights
| Body height | Typical stack gap | Common use |
|---|---|---|
| 5.0 mm | 3.5–4.5 mm | Low profile, no components between boards |
| 7.1 mm | ~6 mm | SMD parts under the board, standard case |
| 8.5 mm | ~7.5 mm | Relays, electrolytics, or airflow between boards |
Those gaps are for a standard 2.54 mm male header with an 11 mm overall pin length. Change the male header and the gap moves, sometimes by 2 mm, without the female part changing at all.
Engagement depth is the constraint you cannot see
A female contact needs the pin inserted past the contact spring, not just into the hole. On a 2.54 mm socket that is around 3 mm of engagement for a reliable connection. If the stack gap is set only by the body height and the pin is short, the pin barely reaches the spring and the contact resistance becomes unstable under vibration.
This failure is invisible on a bench test and obvious on a shaker table. It is also why the drawing should state the mated height, not the body height, when the assembly has a mechanical tolerance chain.
Why body height is a mold decision
Each height is a different mold. 5.0, 7.1 and 8.5 mm are the three that exist because they are the three the market uses; a 6.2 mm body means a new mold, roughly 15 days and a tooling charge, even though the pin layout is identical.
- If you are still in mechanical design, pick from the three standard heights.
- If the enclosure is fixed, choose the height that fits and adjust the male pin length instead.
- If neither fits, a custom height is possible but it is a tooling project, not a catalog order.
Clearance around the body
The plastic body is wider than the pin field. On a 2×10 socket the body adds about 2.5 mm on each side beyond the outer pins. If your layout used the pin field to set the keep-out, the body will land on a via or a test pad.
Check the body outline, not the pin coordinates, against the component keep-out. This is the single most common layout error we see on female headers, and it usually appears as a part that will not sit flat.
Can I stack three boards with these heights?
Yes, but plan the middle board as a pass-through: a female header on top and a male header underneath, with the two aligned. Each additional board adds its own thickness to the tolerance chain.
Does body height affect current rating?
No. The contact and the pin set the rating. A taller body only changes the gap and the amount of plastic around the contact.
Is a 5.0 mm body available in 2×40?
It is, from the same mold family, but the long bodies are more prone to bowing in reflow. Check coplanarity on the first article before committing a production order.
Send the stack gap you need and the male header you plan to use, and we will tell you which of the three heights lands inside the tolerance. All three are in the female header range.