The 3 A figure is for one pin, in free air, at a defined temperature rise, usually 30 °C above ambient. Load every pin in a row and the usable current drops, often to 1.5–2 A per pin, because the heat has nowhere to go. Derate for a sealed enclosure, for high ambient, and for bundled wires.
Almost every current rating argument comes from quoting the datasheet number without the conditions attached to it. The conditions are not fine print, they are the rating.
Where the heat comes from
Contact resistance on a mated 2.54 mm pair is typically 10–20 mΩ. At 3 A that is 0.09–0.18 W per pin. One pin dissipating 0.15 W is nothing. Twenty pins in a row dissipating 3 W in a 40 mm plastic block, inside a closed box, is a different thermal problem.
| Condition | Practical per-pin current |
|---|---|
| Single pin, free air, 25 °C | 3 A |
| All pins loaded, free air | 2 A |
| All pins loaded, sealed enclosure at 60 °C | 1.2–1.5 A |
| Aged contacts, 100+ mating cycles | Derate a further 20% |
Plating and current
Gold does not increase the current rating, it keeps the rating stable. A tin contact oxidises, resistance creeps up over months, and the heat rises with it. In a 3 A design that drift is the difference between a warm connector and a brown one.
Where the current is above 2 A per pin and the connector is not serviceable, specify gold. It costs cents and removes a failure mode you cannot inspect.
Pins versus wires
At 3 A the wire is usually the limiting part, not the header. A 24 AWG wire is comfortable at 3 A; a 28 AWG ribbon conductor is not, and the ribbon is what usually burns. If you are pushing current through IDC, check the conductor cross-section before blaming the connector.
- Two pins in parallel do not double the rating; they share it unevenly unless the copper is balanced.
- Use both pins of a pair for power return: it halves the resistance and the heat per pin.
- Leave a vacant pin between power pins when the layout allows it: it is free thermal isolation.
How to verify without a thermal chamber
Load the connector at the intended current for an hour with the assembly in its real enclosure, then measure the plastic body with a contact thermometer. A rise above 30 °C at 25 °C ambient means you are at the edge of the rating, and the enclosure will be hotter than the bench.
We test to the same 30 °C rise criterion, so a request for "3 A" and a request for "3 A in a sealed box" get different answers.
Does pitch change the current rating?
Yes. A 1.27 mm header has less metal and less surface, so the per-pin rating drops to roughly 1–1.5 A. Density costs current.
Can I run 5 A through one pin?
Short term yes, continuously no. The pin will carry it, the plastic around it will discolour, and the contact spring will lose tension. Use two pins or move to a 3.96 mm or 5.08 mm pitch part.
Does the mating half matter?
Yes. The rating assumes a mating contact with matching normal force. A worn or low-force socket raises resistance and lowers the usable current, even though the header is unchanged.
Tell us the current per pin, how many pins are loaded at once, and the ambient inside the enclosure, and we will tell you whether the standard 2.54 mm part is enough. See the pin header range for the pitch options.