Qualify the second source against the drawing, not against the incumbent part. Run a first article on both, compare the measured values, and repeat only the tests that the process change can affect: pin retention, plating thickness, coplanarity and mating force. Electrical tests on a passive connector rarely need repeating.

The qualification is small if the drawing is good. It becomes a project when the drawing says "2.54 mm header, 2×10, gold" and nothing else, because then you are comparing two interpretations, not two processes.

Start with the drawing, not the samples

Before asking anyone for samples, check that the drawing specifies: contact material and plating thickness on contact area and tail, housing material with a UL file reference, pin retention force, coplanarity for SMT parts, and the dimensional tolerances that matter to your assembly.

  • If the drawing says "gold plated", you cannot compare two quotes. Fix that first.
  • If the housing material is open, a PBT part will be quoted against a PA6T part and both will look compliant.
  • If coplanarity is not stated, a tape-and-reel part and a tube part both pass.

What to actually measure

Characteristic Why it matters Repeat on second source
Pin retention force Predicts field failures Yes
Plating thickness, contact and tail Wear life and solderability Yes
Coplanarity SMT yield Yes, SMT only
Insertion and withdrawal force Assembly feel, wear Yes
Body dimensions Fits the enclosure Yes
Contact resistance Baseline sanity Once, both parts

The cross-reference trap

"Equivalent to brand X" is the most expensive phrase in connector sourcing. Two parts can share a footprint and differ in contact alloy, spring geometry and plating underplate. The differences show up as insertion force and as wear life, neither of which appears on a datasheet comparison.

Ask for the three numbers: contact material, plating thickness with underplate, and insertion force per pin. If a supplier cannot give all three, they are not ready to be a second source.

Running both sources

Once qualified, do not switch 100% of volume on day one. Run 20–30% through the new source for two or three production lots and watch the assembly first-pass yield. Connector problems appear as a yield dip at the placement or test station, not as a return.

Keep the incumbent qualified even after the switch. The point of a second source is availability, and that only works if both are still approved when you need the second one.

How long does qualification take?

With a complete drawing, two to three weeks: samples in 2 working days, first article in a week, then one production lot. Without a complete drawing, add a month for the arguments.

Do I need to requalify the whole product?

Usually not. If the connector is a passive interconnect and the drawing is held, a first article plus the mechanical tests above is proportionate. Check with your customer or certifying body if the product is regulated.

Is a cheaper second source worth the risk?

Only if the saving survives the qualification cost. On a $0.20 part at 10,000 pieces a year, a 15% saving is $300, which does not pay for the engineering time. The reason to second-source is supply security, not price.

Send the drawing you have, even if it is incomplete, and we will tell you which gaps will stop a fair comparison. Capability and tooling are described under capabilities; the plating specification is covered in gold thickness.