Use brass for contacts that are mated once or a few times and carry current. Use phosphor bronze when the contact spring has to keep its force over many cycles, in heat, or under vibration. The price difference is small per part and the failure difference is large.
Both are copper alloys, both plate the same way, and both appear on drawings as "copper alloy" which is a specification that decides nothing.
The two alloys side by side
| Brass (H62/H65) | Phosphor bronze (C5191/C5210) | |
|---|---|---|
| Conductivity | ~28% IACS | ~13% IACS |
| Spring retention | Moderate, relaxes with heat | Good, retains force |
| Formability | Excellent | Good |
| Cost | Lower | 15–30% higher |
| Typical use | Pin headers, male pins | Female contacts, spring terminals |
That last row is the practical answer for most designs: brass pins, phosphor bronze sockets. The pin does not need spring; the socket does.
Why the socket is the part that matters
A male pin is a rigid post. Its only job is to be straight, plated and the right diameter. A female contact is a spring: two or four beams that deflect on insertion and must still push back after hundreds of cycles and thousands of hours at temperature.
Brass in that role works when the part is new. At 85 °C, brass stress-relaxes faster, the beams take a set, and the normal force drops. The connection still conducts, but it becomes sensitive to vibration and to thermal cycling.
Where brass is the right answer
- Male pins in a header, where the geometry is rigid.
- Board-to-board connectors mated once at assembly.
- High-current paths where conductivity matters and cycles do not.
- Cost-driven consumer parts with a two-year life.
Where it is the wrong answer: anything in a machine that is serviced, anything above 70 °C ambient, anything with a cable that vibrates, and anything with a warranty longer than three years.
Insertion force is the visible symptom
Two connectors can have the same footprint and different insertion force: 0.5 N per pin against 1.5 N per pin. On a 2×20 header that is 10 N against 30 N, which is the difference between a connector an assembler seats with a thumb and one they seat with a tool.
High force is not automatically better. It wears the plating faster and it bends boards. The right number is the one that keeps normal force adequate without making assembly a two-hand operation. See insertion force your line can feel.
Can I mix brass pins with phosphor bronze sockets?
Yes, that is the standard combination and it is what most catalog pairs already are. What you should not mix is plating: gold on one side, tin on the other.
Does the alloy change the current rating?
Yes, slightly. Brass carries more current for the same cross-section. On a 3 A pin the difference is a few degrees of temperature rise, not a rating change.
Is phosphor bronze necessary for 30 µin gold parts?
Usually yes. If you are paying for 30 µin gold you are expecting many cycles, and a brass spring will relax before the gold wears out.
Tell us the cycle count, the ambient temperature and the insertion feel you want, and we will quote the alloy that holds it. Both are available across the female header range.