Two layout details cause most header bridging: pads that are too close with no solder mask dam between them, and the connector oriented so the pins run parallel to the wave. Fix the mask dam first, then rotate the part 90° if the panel allows it.

Bridging is usually blamed on flux chemistry or on solder temperature. Those matter, but a layout with a proper dam and the right orientation will not bridge at the same settings that bridge a bad one.

The two details

Detail Target Effect if wrong
Solder mask dam between pads 0.15 mm minimum, 0.2 mm preferred Molten solder joins adjacent pads
Connector orientation Pins perpendicular to the wave direction Each pin shadows the next; bridging along the row
Pad-to-pad gap 0.5 mm at 2.54 mm pitch Less gap means less dam
Thermal relief on ground pins Two spokes minimum Cold joint on the pin connected to a plane

Why orientation matters so much

The wave travels across the board as a standing crest. If the pin row runs parallel to that crest, each pin sits in the shadow of the one before it, the solder cools in the gap, and the bridge forms between them. Rotate the connector so the pins cross the wave and each one sees fresh solder.

On a panel with several headers this can conflict: one is right and another is wrong. Where that happens, add a solder thief pad or adjust the wave angle, but do not accept a parallel orientation on a long row.

The mask dam and the stencil

The dam is a strip of solder mask between two pads, and its width is set by the mask registration capability of the fab. A 0.15 mm dam on a board with poor registration becomes a mask sliver that lifts, which is worse than no dam.

  • Ask the fab what minimum dam it can hold reliably; 0.15 mm is typical, 0.1 mm is optimistic.
  • Do not put a via in the dam area; it wicks solder away and leaves a thin joint.
  • Keep the mask opening equal to the pad, not larger. An oversized opening removes the dam.

Ground pins and thermal relief

A pin connected to a ground plane acts as a heat sink. The joint stays below soldering temperature while the neighbouring pins flow, and you get a cold joint on exactly the pin that carries the return current.

Use a thermal relief with two or four spokes on those pins. It slows the heat loss enough for the joint to form without making the connection inductive.

Does lead-free solder make bridging worse?

Yes. Lead-free has a narrower process window and higher surface tension, so a layout that was marginal with SnPb will bridge. Increase the dam and check the wave angle first.

Can selective soldering avoid the problem?

Yes, because each joint gets its own nozzle and heat. It is slower and needs a fixture, so it is usually reserved for boards with a few connectors and many SMT parts.

Is a 1.27 mm header possible in wave solder?

Rarely. The gap between pads is too small for a reliable dam, and bridging becomes the normal outcome. Use reflow for fine pitch.

Send the layout and the wave direction and we will check the orientation before the panel is released. Related: tail length and board thickness, and SMT or through-hole.